STREAMER codifica e distribuisce un segnale audio in formato MP2 e MP3 su protocollo IP, tramite la porta Ethernet in dotazione.
E' una soluzione economica e professionale broadcast per applicazioni che richiedono lo streaming su reti IP, prevedendo un o più punti ri ricezione.

STREAMER supporta i formati compressi MP2 (MPEG1 Layer II) e MP3 (Layer III). La configurazione è personalizzabile dall'utente tramite il software in dotazione , che lo rende ideale per trasmissioni di segnali audio compressi, musicali e non, su reti standard IP.

Audio
- Format: (TX) MPEG1/2-Layer III (RX) MPEG1/2-Layer II and III for UDP (raw) audio streaming
- Bit rate encoding: VBR from 32 to 192 Kb/sec (MPEG1-L3), from 8 to 160 Kb/sec (MPEG2-L3)
- Sampling frequency: 16/22,05/ 24/32/44,1/48 Khz
- Bit rate decoding: from 32 to 384 Kb/sec (MPEG1-L2), from 32 to 320 Kb/sec (MPEG1-L3), from 8 to 160 Kb/sec (MPEG2-L2/3)
- Sampling frequency: 8/11,025/ 12/16/22, 05/24/32/44,1/48 Khz
- Mode: stereo, joint stereo, dual channel, single channel
- Audio Input: line stereo unbal. analog input (PinRca), line stereo balanced on terminal blocks (optional)
- Audio Out : line level on 3.5 mm jack connector, line stereo balanced on terminal blocks (optional)
- Frequency response: 20 - 20.000 Hz (+/- 3 dB)
- Signal to noise: ratio > 94 dB
- Crosstalk: <-80 dB,
- THD 0,003%

Network: Interface RJ45 female connector full duplex IEEE 802.3 10/100 Mb/s protocols UDP (raw) encoding/decoding, HTTP (TCP) only decoding
Remote Control: Via internet, local ethernet network by Software or API
Power requirement: 12/24V DC or AC 90 mA (6 mm coaxial connector) - Power Supply Unit included
Dimensions: 110 x 80 x 30 mm

• Streamer Brochure Eng.pdf - 686.34 KB
• Streamer, In-Streamer ITA 1.2.pdf - 4.33 MB